|
With the ignition switch at the ACC position and the audio power OFF, press the button in the following order.
- Press the [CH1] button.
- Press the fast rewind button.
- Press the fast forward button.
- Press the [CH6] button.
| note |
To start the speaker check mode, perform the button operations above within 60 seconds since turning OFF the audio power.
|
|
|
|
With the speaker connection check mode, the connection status of each speaker can be checked based on the sound output from each speaker. The procedure is as follows.
|
|
1.At the same time with the start of speaker check mode, the sound for speaker connection check is output from the front door speaker (LH). Check the speaker connection of front door speaker (LH) based on this sound output.
2.Press the [CH6] button to switch the sound output for speaker check from the front door speaker (LH) to the front door speaker (RH). Check the speaker connection of front door speaker (RH) based on the output of speaker connection check sound from the front door speaker (RH).
3.Press the [CH6] button again to switch the sound output for speaker check from the front door speaker (RH) to the rear door speaker (LH). Check the speaker connection of rear door speaker (LH) based on the output of speaker connection check sound from the rear door speaker (LH).
4.Press the [CH6] button again to switch the sound output for speaker check from the rear door speaker (LH) to the rear door speaker (RH). Check the speaker connection of rear door speaker (RH) based on the output of speaker connection check sound from the rear door speaker (RH).
|
|
|
Inserting a CD during the speaker connection check mode shifts the mode to the chattering check mode, and the chattering sound of each speaker can be checked.
|
|
|
As with the speaker connection check mode, press the [CH6] button to switch the output speaker of the chattering check sound.
|
|
|
Check that the chattering sound is output from the output speaker of chattering check sound.
|
)
)