If the diagnosis
code No. U0155 is set to the ETACS-ECU, always diagnose the CAN bus line.
Before replacing the ECU, ensure that the communication circuit is normal.
DIAGNOSTIC FUNCTION
If the signal from combination meter cannot be received, the ETACS-ECU sets the diagnosis
code No. U0155.
JUDGMENT CRITERIA
After the following statuses continue to be true for 5 seconds, if the communication with
the combination meter cannot be established for 2,500 ms or more, the ETACS-ECU determines that
a problem has occurred.
No abnormality is present to the network.
Ignition switch is in the ON position.
No abnormality is present to the power supply fuse, or the odometer value is at
80.5 km or more.
ETACS-ECU system voltage is at 10-16 V.
PROBABLE CAUSES
Malfunction of combination meter
Malfunction of the ETACS-ECU
Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
STEP 2. M.U.T.-III other system diagnosis code
Check if diagnosis code is set to the combination meter.
Q.
Is the diagnosis code set?
Troubleshoot the combination meter. Refer to .
Go to Step 3.
STEP 3. M.U.T.-III other system diagnosis code
Check if the diagnosis code No. U0155 is set to the KOS-ECU, WCM, 6-disc CD changer and
AM/FM radio, SRS-ECU, or A/C-ECU.
Q.
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
STEP 4. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the ETACS-ECU.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the combination meter.
The trouble can be an intermittent malfunction such as a poor connection or open
circuit in the CAN bus lines between the combination meter and the ETACS-ECU (Refer to GROUP
00 -
How to use Troubleshooting/inspection Service Points -
How to
Cope with Intermittent Malfunction ).
STEP 5. Check whether the diagnosis code is reset.
Check again if the diagnosis code is set to the ETACS-ECU.
(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.
Q.
Is the diagnosis code set?
Replace the ETACS-ECU.
The trouble can be an intermittent malfunction such as a poor connection or open
circuit in the CAN bus lines between the combination meter and the ETACS-ECU (Refer to GROUP
00 -
How to use Troubleshooting/inspection Service Points -
How to
Cope with Intermittent Malfunction ).
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting 
).