Inspection Procedure 8: The rear display does not change to nighttime brightness when the headlamps are illuminated.
|
STEP 1. M.U.T.-III other system diagnosis code
|
|
Check if diagnosis code is set to the combination meter.
|
|
Q.
Is the diagnosis code set?
|
|
Troubleshoot the combination meter (Refer to ).
|
|
|
|
Go to Step 2.
|
|
|
|
STEP 2. M.U.T.-III other system diagnosis code
|
|
Check if the diagnosis code is set to the ETACS-ECU.
|
|
Q.
Is the check result normal?
|
|
Troubleshoot the ETACS-ECU (Refer to Grup 54A -
ETACS -
Troubleshooting ).
|
|
|
|
Go to Step 3.
|
|
|
|
STEP 3. Connector check: C-03 combination meter connector
|
|
Q.
Is the check result normal?
|
|
Go to Step 4.
|
|
|
|
Repair the connector concerned.
|
|
|
|
STEP 4. Voltage measurement at C-03 combination meter connector
|
|
(1)Disconnect the connector, and measure at the wiring harness side.
|
|
(2)Turn the ignition switch to the OFF position.
|
|
(3)Measure the voltage between C-07 combination meter connector terminal No.24 and the body earth. OK: Battery voltage
|
|
Q.
Is the check result normal?
|
|
Go to Step 6.
|
|
|
|
Go to Step 5.
|
|
|
|
STEP 5. Wiring harness check between C-317 ETACS-ECU connector terminal No.2 and C-07 combination meter connector terminal No.24
|
|
- Check the power supply line for open circuit.
|
|
Q.
Is the check result normal?
|
|
Replace the ETACS-ECU.
|
|
|
|
Repair the wiring harness.
|
|
|
|
STEP 6. Check the wiring harness wires between C-03 combination meter connector terminal No.23 and D-06 rear display unit connector terminal No.5.
|
|
note |
Prior to the wiring harness inspection, check intermediate connector D-122, and repair if necessary.
|
|
|
- Check the power supply line for open circuit.
|
|
Q.
Is the check result normal?
|
|
Replace the rear display unit.
|
|
|
|
Repair the wiring harness.
|
|
|