Tool
|
Number
|
Name
|
Use
|
|
MB991367
|
Special spanner
|
Removal and installation of the A/C compressor armature mounting nut
|
|
MB991386
|
Pin
|
|
MB990900 or MB991164
|
Door hinge adjusting wrench
|
Removal and installation of front deck cross member heater unit assembly
|
|
MB991658
|
Test harness
|
Inspection of the A/C pressure sensor
|
|
MB991223
A: MB991219 B: MB991220 C: MB991221 D: MB991222
|
Harness set
A: Test harness B: LED harness C: LED harness adapter D: Probe
|
Making voltage and resistance measurements during troubleshooting
A: Connect pin contact pressure inspection B: Power circuit inspection C: Power circuit inspection D: Commercial tester connection
|
|
MB992006
|
Extra fine probe
|
Continuity check and voltage measurement at harness wire or connector
|
|
MB991955 A: MB991824 B: MB991827 C: MB991910 D: MB991911 E: MB991825 F: MB991826
|
M.U.T.-III sub-assembly A: Vehicle Communication Interface (V. C. I). B: USB cable C: M.U.T.-III main harness A (applicable to vehicles with CAN communication) D: M.U.T.-III main harness B (applicable to vehicles without CAN communication) E: Measurement adapter F: Trigger harness
|
Check the A/C (The M.U.T.-III DTCs display, service data display and actuator test)
caution |
For vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
|
|