CODING LIST


caution With the ETACS functions being customised, if any of the ETACS-ECU variant coding and option coding items are changed, the customised contents are reset. In such case, the functions need to be recustomised.
Before troubleshooting, check that the coding data written into the engine-ECU and ETACS-ECU are normal. If they are not the same as the initial settings, various functions and systems do not work normally.

VARIANT CODING


caution The items marked with *3 are actually installed to a vehicle but their initial settings are "Not present." This is because the items do not adapt CAN, and does not indicate abnormal coding data.
The coding data can be checked by operating M.U.T.-III.


note For details on how to use the M.U.T.-III, refer to the "M.U.T.-III operation manual."
1.Ensure that the ignition switch is at the "LOCK" (OFF) position.
2.Start up the personal computer.
3.Connect special tool M.U.T.-III USB cable (MB991827) to Vehicle Communication Interface (V.C.I.) (MB991824) and the personal computer.
4.Connect M.U.T.-III main harness A (MB991910) to the V.C.I.
5.Connect the M.U.T.-III main harness A to the diagnosis connector.
6.Turn the V.C.I. power switch to the "ON" position.
note When the V.C.I. is energized, the V.C.I. indicator lamp will be illuminated in a green colour.
7.Start the M.U.T.-III system on the personal computer and turn the ignition switch to the "ON" position.
8.On the system selection screen, select "Diesel-ENG" to check the engine-ECU data, and "ETACS" to check the ETACS-ECU data.
9.Select "Coding."
10.Select "Coding Information."
11.If the displayed coding information is different from the corresponding initial setting in the list, replace the ECU with a correctly coded one. For replacement of the engine-ECU, refer to GROUP 13A - Engine-ECU <BSY>, GROUP 13C - Engine-ECU <6B3> or GROUP 13D - Engine-ECU <4B1>. For replacement of the ETACS-ECU, refer to GROUP 54A - ETACS .

ENGINE ECU CODING DATA LIST


note The items to be displayed may differ depending on the version of the M.U.T.-III.

<4B1, 6B3>
Item name
 Initial value
Final gear ratio
5MT <MT>
6.466 <CVT>
3.571 <A/T>
Tyre circumference
 2155mm
Immobilizer
 Present
ABS
 Not present <Vehicles without ABS>
Present <Vehicles with ABS>
ASC
 Not present <Vehicles without ASC>
Present <Vehicles with ASC>
S/W variation
 No.1

<BSY>
Item name
 Initial value
Dataset
 ABS (OUTLANDER) or ASC (OUTLANDER)
Cruise control
 Not present or present

ETACS-ECU CODING DATA LIST


note The items to be displayed may differ depending on the version of the M.U.T.-III.
Item name
 Initial value
Vehicle line
 OUTLANDER
Model year
 (Displays the model year)
Destination
 EUR
Transmission
 5MT <5M/T>
6MT <6M/T>
CVT <CVT>
6AT <6A/T>
Engine type
 DIESEL 2.0L <BSY>
DIESEL 2.2L <4HN>
D4 V.V.T. 2.4L <4B1>
S4 MIVEC <6B3>
Engine power
 Normal <4HN, 4B1, 6B3>
High power <BSY>
Handle side
 LHD or RHD
Chassis type for A.S.C.
 Type 3 <BSY, 4HN, 4B1>
Type 4 <6B3>
Final drive
 Front Drive <2WD>
4WD FF Base <4WD>
Transfer
 2WD <2WD>
ECC <4WD>
Tyre size
 215/70R16 or 225/55R18
Tyre circumference
 2155mm
Fuel tank
 Not used
DRL*1 type
 Normal DRL
Smart entry system
 Not present or Type B
TPMS*1
 Not present
Keyless entry*2
 Not present or present
Immobilizer
 Type A
Cruse control
 Not present or Present
Corner sensor
 Not present or Present
Head lamp auto levelling device
 Not present or Present
Oil level warning
 Not present
Water separate warning
 Not present
Speed meter scale
 Not used
Idle neutral control
 Not used
ENG-CVT unit control
 Not used
INVECS control
 Not used
Look-up slip control
 Not used
Side air bag
 Not present or Present
Number of speaker*2
 Premium or 6 speakers
Seat material*2
 Fabric or Leather
Auto lamp control
 Hi ANLG/Chg Ng or Hi RLS/Chg Ng
Front differential
 Open
Rear differential
 Open <BSY, 4HN, 4B1>
Undefined <6B3>
Power window type
 Type P1
Sunroof type
 Not present or Type S2
WCM
 Present
OCM
 Not present
ORC
 Present
A/C
 Present
AUDIO*2
 Not present or Present
AND*3
 Not present or Present
VES*3
 Not used
DISP*3
 Not used
NAVI*2*3
 Not used
CAMERA*3
 Not present
TUNER*3
 Not used
Electric Slide door (Left)
 Not present
Electric Slide door (Right)
 Not present
ETG
 Not present
MSMD
 Not used
HFM
 Not present or Present
ABS
 Not present or Present
A.S.C.
 Not present or Present
SAS
 Not present or Present
4WD
 Not present <2WD>
Present <4WD>
TCM
 Not present <M/T>
Present <CVT, A/T>
ACTV_STB
 Not used
Pre-Crush
 Not used
EPS
 Not present
ACDAYC
 Not present
Power window Dr
 Present
Power window As
 Present
Power window RR
 Present
Power window RL
 Present
Power window BK
 Not used
Sunroof
 Not present or Present
RLS*2
 Not present or Present
IG key illumination
 W/o getting off or W/ getting off
Turn signal bulb
 21W+21W+5W
Rear wiper
 Enable
Fold mirror
 Enable
Head lamp
 4 beams
Head lamp washer
 Disabled or Popup2 w/ washer
Front fog lamp mode
 B spec.
Front fog lamp*2
 Not present or Present
Rear fog lamp*2
 Present/ChgNg
Room lamp delay timer/door & H/L
 Short
Room lamp by H/L
 Disabled or Full
Gate/Trunk lamp
 Mode-2 (cargo)
Head lamp auto cut mode
 B-spec
Head lamp auto cut
 Enable
Door lock system
 B-spec/exceptUSH or E-spec/exceptDLH
Auto door lock/unlock
 Disabled
key remainder unlock
 Disabled
Horn type*2
 Dual horn
Gate/trunk opener mode
 Present
Cooling fan
 Relay control
Security alarm mode
 Not present
Security alarm function
 Not present/ChgNg
Pre-alarm
 Not present
Multi mode RKE
 Disabled or Enable
Gate/Trunk
 Gate type
Manner switch*2
 Not present/ChgNg
Remote engine starter*2
 Not present/ChgNg
Panic Alarm
 Disabled
Front wiper
 Speed Sensitive or Rain Sensitive
Comfort flasher type
 Present/Chg Ok
Room lamp Centre Switch
 Not present
Wiper washer check bulb
 Present
AUDIO/S.RADIO type
 AM MW/LW or Other
H/L levelling type
 Not present or Com less/static
AFS*1/ACL type
 Not present
ARS*1 type
 Not present
Compressor type
 Scroll 90 cc
Temperature type
 Celsius
Rear view camera
 Not present or Present
Nose view camera
 Not present
Side view camera
 Not present
Average speed
 Available
Vehicle language status
 English
Fuel amount
 Not used
Fuel consumption scale
 L/100 km or MPG (UK)
Speed gauge tolerance
 Japan/EUR
Coolant temp gauge threshold
 Normal
Frost warning threshold
 EUR
Distance to empty
 Available
Average fuel consumption
 Available
Instant fuel consumption
 Available
Time travelled
 Not available
Distance travelled
 Not available
Fuel used
 Not available
Trip autoreset IG OFF
 Available
Variable speed alarm
 Not available
Rest reminder
 Available
Instant speed
 Not available
Seat belt reminder type
 Type 0
Seat belt reminder flashing
 Available
Seat belt reminder indicator
 D and P independent
Reverse alarm
 Not available
Key reminder
 Not available
Lighting monitor
 Available
GCC speed alarm
 Not available
Condition buzzer
 Not available
Rent-a-car mode IG-OFF always
 Available
Rent-a-car mode IG-OFF door open
 Available
Service reminder schedule table
 EU 10 <BSY, 4B1, 6B3>
EU 11 <4HN>
ACD control display
 Not used
Tpms information
 N/A
Horn chirp by keyless
 Not present/ChgNg
Rear S/R unlock output
 Not present
Trailer turn detection
 Present
LEVER
 Not present
AFS/ACL
 Not present
Satellite Radio
 Not present
Fuel tank type
 Not used
KOS auto lock customize
 Not used
DRL function
 NotPresent/Chg Ok or Present/Chg Ok
FACU
 Not present <BSY, 4B1, 6B3>
Present <4HN>
S-AWC control display
 Not available
Diesel particulate filter
 Not present <BSY, 4B1, 6B3>
Present <4HN>
Language mode
 Available
WSS
 Not present
RLS overwipe type
 Type 2
RLS WS type
 Type 2 (Green)
note
  • *1 : TPMS is an abbreviation of Tyre Pressure Monitoring System, DRL of Daytime Running Light, AFS of Adaptive Front lighting System, and ARS of Advanced Rear lighting System. However, the systems are not used for this vehicle.
  • *2 : The setting can be changed by the option coding. Refer to .
  • *3: The item is actually installed to a vehicle, but its initial setting is "Not present." This is because the item does not adapt CAN, and does not indicate abnormal coding data.

OPTION CODING


caution
  • If there is any item indicated by the option coding after equipment change, set ETACS-ECU so that the option coding data corresponds with the equipment content. Pay attention to that the concerned functions and systems do not work normally if the setting does not correspond with the equipment.
  • With the ETACS functions being customised, if any of the ETACS-ECU option coding items are changed, the customised contents are reset. In such case, the functions need to be recustomised.
The ETACS-ECU option coding data can be checked or changed by operating M.U.T.-III.



LIST
Item name
Auto lamp CNTL
AUDIO (CAN)
Rain light sensor
Number of speaker
Seat material
Front fog lamp
Rear fog lamp
Horn type
Manner switch
Remote engine starter
AND
HFM
Satellite radio
Compressor type
DRL function
Wiper washer check bulb