REMOVAL AND INSTALLATION <6B3>


Pre-removal Operation
  • Engine Coolant Draining <4B1, 6B3> (Refer to ).
  • Air Cleaner Assembly Removal (Refer to GROUP 15 - Air Cleaner <6B3> ).

 Post-installation Operation
  • Air Cleaner Assembly Installation (Refer to GROUP 15 - Air Cleaner <6B3> ).
  • Engine Coolant Refilling <4B1, 6B3> (Refer to ).




Radiator removal steps


·
 Engine room under cover front A, B (Refer to GROUP 51 - Under Cover ).


1.
 Radiator drain plug


2.
 O-ring


3.
 Radiator cap


4.
 A/T fluid cooler feed hose assembly


5.
 Radiator condenser tank hose
<<A>>
 >>A<<
 6.
 Radiator upper hose


7.
 Radiator cap assembly
<<A>>
 >>A<<
 8.
 Radiator upper hose


9.
 Radiator hose clamp
<<A>>
 >>A<<
 10.
 Radiator lower hose


11.
 Radiator hose support


12.
 Radiator fan motor connector


13.
 Condenser fan motor connector


14.
 Fan, fan motor and fan shroud assembly


·
 Radiator grille, headlamp support upper panel cover (Refer to GROUP 51 - Radiator Grille ).


·
 Front impact sensor (Refer to GROUP 52B - Front Impact Sensor ).


·
 Hood lock release cable, hood switch (Refer to GROUP 42A - Hood ).


15.
 Headlamp support panel upper


16.
 Support upper insulator


17.
 Radiator assembly


18.
 Support lower insulator


19.
 Radiator condenser tank


20.
 Radiator condenser tank bracket



Fan shroud removal steps


5.
 Radiator condenser tank hose
<<A>>
 >>A<<
 6.
 Radiator upper hose


7.
 Radiator cap assembly


12.
 Radiator fan motor connector


13.
 Condenser fan motor connector


14.
 Fan, fan motor and fan shroud assembly


21.
 Radiator fan


22.
 Radiator fan motor


23.
 Condenser fan


24.
 Condenser fan motor


25.
 Fan shroud

REMOVAL SERVICE POINT

<<A>> RADIATOR UPPER HOSE/RADIATOR LOWER HOSE DISCONNECTION

Make mating marks on the radiator hose and the hose clamp. Disconnect the radiator hose.

INSTALLATION SERVICE POINT

>>A<< RADIATOR LOWER HOSE/RADIATOR UPPER HOSE INSTALLATION

1.Insert each hose as far as the projection of the water inlet fitting, thermostat housing or radiator.
2.Align the mating marks on the radiator hose and hose clamp, and then connect the radiator hose.