|
Remove the connection and clamp of oxygen sensor connector, and then use special tool oxygen sensor wrench (MB991953) to remove the oxygen sensor.
|
|
Use a drill (6.0 mm) to make a hole in the rivet to break it, and then remove the rivet.
|
|
Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the parts is fixed in position.
|
|
Tighten the oxygen sensor to the specified torque by using special tool oxygen sensor wrench (MB991953).
Tightening torque: 50 ± 10 N·m
|
)
).)
)
)