|
1.Set the selector lever to the "N" position.
|
|
2.Loosen the control cable to the manual control lever adjusting nut to free the cable and lever. 3.Set the manual control lever to the neutral position.
|
|
4.Loosen the inhibitor switch body mounting bolts and turn the inhibitor switch body so the hole in the end of the manual control lever and the hole (section A - A in the figure on the left) in the flange of the inhibitor switch body flange are aligned.
note |
The inhibitor switch body can be aligned by inserting a 5-mm diameter steel bar into the end hole of the manual control lever and the flange hole of the inhibitor switch body.
|
5.Tighten the inhibitor switch body mounting bolts to the specified torque. Be careful at this time that the switch body does not move. Tightening torque: 5.9 ± 1.0 N·m
|
|
6.Tighten the transmission control cable using the adjusting nut with the specified torque. Tightening torque: 9.5 ± 3.5 N·m 7.Check that the selector lever is in the N position. 8.Check that each position of the manual control lever matches each position of the selector lever using M.U.T.-III MB991958 (M.U.T.-III sub assembly).
|