|
Check that P0715 (input shaft speed sensor) and P0720 (output shaft speed sensor) are set.
|
|
Q.
Is the diagnosis code set?
|
|
Check and repair the relevant diagnosis code system.
|
|
|
|
Check that the diagnosis code other than P0729, P0732, P0733, P0734, P0735 (6th, 2nd, 3rd, 4th, 5th gear ratio) is set.
|
|
Q.
Is the diagnosis code set?
|
|
Check and repair the relevant diagnosis code system.
|
|
|
|
Check the status of the A/T fluid properties (smell, colour, fouling).
|
|
- Black: A/T inside damage, seizure
- Milky: Water intrusion
|
|
Q.
Is the check result normal?
|
|
Remove the A/T from the vehicle, then check and repair the inside.
|
|
|
|
Q.
Is the check result normal?
|
|
Adjust the A/T fluid level, and then go to Step 5.
|
|
|
|
Check the signals of C-137 A/T-ECU connector terminal No. 37 and No. 38.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the failure section.
|
|
|
|
Q.
Is the check result normal?
|
|
Remove the A/T from the vehicle, then check and repair the inside.
|
|
|
|
Check that the normal code is displayed.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete.
|
|
|