|
[C-138 A/T-ECU connector (vehicle side, connected)]
|
|
Measure the voltage between the terminal No. 1 and body earth.
|
|
- High clutch engaged: 0 V
- Other than above: 300 Hz
|
|
Q.
Is the check result normal?
|
|
Check for continuity between C-138 A/T-ECU connector and B-132 A/T control solenoid valve assembly connector.
|
|
- Between C-138 terminal No. 1 and B-132 terminal No. 19: Continuity exists.
|
|
When the continuity check result is OK, check that the wiring harness is not shorted to the body and other wiring harness.
|
|
Q.
Is the check result normal?
|
|
Repair or replace the failure section.
|
|
|
|
Q.
Is the check result normal?
|
|
Check for continuity between the A/T control solenoid valve assembly connector terminals and the high clutch linear solenoid valve connector terminals.
|
|
- Between B-132 terminal No. 19 and high clutch linear solenoid valve: Continuity exists.
|
|
Q.
Is the check result satisfactory?
|
|
Replace the valve body assembly.
|
|
|
|
Repair or replace the failure section.
|
|
|
|
Q.
Is the check result normal?
|
|
Repair or replace the failure section.
|
|
|
|
Q.
Is the check result normal?
|
|
Repair or replace the failure section.
|
|
|
|
Check that the normal code is displayed.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete.
|
|
|