DIAGNOSIS CODE CHART


caution
  • On troubleshooting, if the ignition switch is turned ON while disconnecting connector(s), diagnosis code(s) associated with other system may be set. On completion, confirm all systems for diagnosis code(s). If diagnosis code(s) are set, erase them all.
  • Before or after the troubleshooting, check the operation of the headlamp automatic levelling system. Refer to .
Diagnosis code No.
 Diagnostic item
 Reference page
B2510
 Auto levelling initialization not completed
B2511
 ECU internal error (ROM)
B2512
 ECU internal error (EEPROM)
B2513
 Levelling actuator output error
B2514
 Height sensor power supply error
B2515
 Front height sensor signal error
B2516
 Rear height sensor signal error
U0001
 Bus-off (CAN-C)
U0100
 Engine CAN time-out
U0121
 ASC/ABS CAN time-out
U0141
 ETACS CAN time-out
U0145
 Coding not completed/failed
U0147
 Abnormality in coding data