|
1.When installing the new gate pillar reinforcement, to prevent the sound dampening foam
material to be filled into the gate pillar inside in the next process from dripping, machine
the body loose panel cushion (MR435765 or MR565301) and adhere it to the body side.
|
|
2.After installing the quarter inner panel, the inside of rear pillar cannot be filled with
sound dampening foam material, therefore, machine the body loose panel cushion (MR435765 or
MR565301) shown in the figure as an alternative and insert it into the rear pillar.
|
|
3.When assembling a new rear pillar reinforcement lower, to prevent the sound dampening
foam material to be filled into the wheel arch inside from dripping, machine the body loose panel
cushion (MR435765 or MR565301) and adhere it to the body side.
|
|
4.After installing the gate pillar reinforcement, seal the hole and flange with bolt and
aluminium tape, and then fill the hole with sound dampening foam material the hole as shown
in the figure.
Sound dampening foam material: 3M ATD Part No.08463
|
|
5.After installing the rear pillar reinforcement lower, seal the hole and flange with bolt
and aluminium tape, and then fill the hole with the sound dampening foam material as shown in
the figure of the instructions.
Sound dampening foam material: 3M ATD Part No.08463
|
|
6.Wait 2 hours after filling the sound dampening foam material to remove the bolt and aluminium
tape, then melt the sound dampening foam material with a soldering gun to ensure that a clip,
etc. can be inserted in the hole filled with sound dampening foam material.
|