|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
2.
warning |
Use care as engine oil could be hot.
|
Remove the engine oil filler cap.
|
|
3.Remove the engine oil pan drain plug to drain engine oil.
|
|
4.Install a new engine oil pan drain plug gasket so that it faces in the direction shown
in the illustration, and then tighten the engine oil pan drain plug to the specified torque. Tightening torque: 39 ± 5 N·m
|
|
5.Refill with specified quantity of engine oil. Specified Engine Oil
- ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5
- ILSAC classification: ILSAC certificated oil
- API classification: SM or higher
Total quantity (Includes volume inside engine oil filter):
<6B3> 4.3 L <4B12-EUROPE> 4.6 L <4B12-RUSSIA> 4.7 L <4B11-M/T> 4.3 L <4B11-CVT> 4.4 L
note |
SAE 0W-20*, 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet
ACEA A3/B3, A3/B4 or A5/B5 and API SM or higher specifications.
|
6.Install the engine oil filler cap. 7.Let the engine run for a few minutes. 8.Stop the engine, and then check the engine oil level using the oil dipstick after
a few minutes.
|