REMOVAL AND INSTALLATION

M11103000013ENG0000010000

			Removal steps
		1.	Cooling fan
		2.	Fan clutch
		3.	Cooling fan bracket
		4.	Cooling fan pulley
		5.	Idler pulley
		6.	Idler pulley
		7.	Auto tensioner
		8.	Alternator
		9.	Accessory mount stay
	>>B<<	10.	Timing indicator bracket
		11.	Accessory mount
<<A>>	>>A<<	12.	Crankshaft bolt
		13.	Crankshaft pulley washer
		14.	Damper pulley

REMOVAL SERVICE POINT

<<A>> CRANKSHAFT BOLT LOOSENING

1. Lock the drive plate with the special tool Flywheel Stopper (MD998781).
2. Remove the crankshaft bolt.

INSTALLATION SERVICE POINT

>>A<< CRANKSHAFT BOLT TIGHTENING

1. Lock the drive plate with the special tool Flywheel Stopper (MD998781).

2. Clean the threaded holes in the crankshaft.
3. Clean and degrease the crankshaft pulley.

note

Degreasing is required to prevent any remaining oil from compromising the friction coefficient of the pulley belt contact surface.

4. Install the damper pulley.
5. Apply an appropriate minimum amount of engine oil to the threaded portion as well as the flange bottom of the crankshaft.
6. Clean the washer.
7. Tighten the crankshaft bolt to 185 N·m.

>>B<< TIMING INDICATOR BRACKET

caution

Install harness bracket together when installing timing indicator bracket.

Harness shall be not to sag between

Tighten the timing indicator bracket bolt of 11 ± 1 N·m