This test determines whether the voltage regulator correctly controlling the alternator
output voltage. 1.
Always be sure to check the following before the test.
Alternator installation
Check that the battery installed in the vehicle is fully charged. (Refer to GROUP 54A - Battery - On-vehicle Service - Charging ).
Drive belt tension (Refer to GROUP 11A - On-vehicle Service Drive Belt Tension Check and Adjustment ).
<6G7> (Refer to GROUP 11C - On-vehicle Service - Drive Belt Tension Check
and Adjustment ). <4M4>
Fusible link
Abnormal noise from the alternator while the engine is running
2.
Turn the ignition switch to the "LOCK" (OFF) position. 3.
Disconnect the negative battery cable. 4.
Use the special tool Alternator test harness (MB991519) to connect a digital voltmeter between
the alternator "S" terminal and earth [Connect the (+) lead of the voltmeter to the "S" terminal,
and then connect the (-) lead of the voltmeter to a secure earth or to the battery
(-) terminal]. 5.
Connect a clamp-type DC test ammeter to the alternator "B" terminal output wire. 6.
Reconnect the negative battery cable. 7.
Connect the M.U.T.-III. 8.
Turn the ignition switch to the "ON" position and check that the reading on the voltmeter
is equal to the battery voltage.
note
If the voltage is 0 V, the cause is probably an open circuit in the wire or fusible link
between the alternator "S" terminal and the battery (+) terminal.
9.
Turn all lamps and accessories off. 10.
Start the engine. 11.
Increase the engine speed to 2,500 r/min. 12.
Read the value displayed on the voltmeter when the alternator output current alternator
becomes 10 A or less. 13.
If the voltage reading conforms to the value in the voltage regulation, then the voltage
regulator is operating normally. If the voltage is not within the standard value, there is a malfunction of the voltage
regulator or of the alternator. 14.
After the test, lower the engine speed to the idle speed. 15.
Turn the ignition switch to the "LOCK" (OFF) position. 16.
Remove the M.U.T.-III. 17.
Disconnect the negative battery cable. 18.
Disconnect the ammeter and voltmeter. 19.
Remove the special tool, and return the connector to the original condition. 20.
Connect the negative battery cable.
)
).