| 1.
The rear suspension, wheel and tires must be serviced
to normal condition before measuring the wheel alignment.
|
| 2.
Measure the wheel alignment with the vehicle parked on a level surface.
|
| Standard value: 0° 00' ± 30' (difference between right and left
wheels: less than 30')
|
| Use the compensator to measure camber.
If camber is not within the standard value, adjust by following procedures.
|
| 1.
Adjust by turning the camber adjusting bolt of the lower arm.
Left wheel: Turning clockwise (-) camber
Right wheel: Turning clockwise (+) camber
2.
After adjusting the camber, the toe-in should be adjusted.
|
| Standard value:
At the centre of tyre tread: 3 ± 3 mm
Toe angle (per wheel): 0°06' ± 0°06'
|
| If toe-in is not within the standard value, adjust as follows.
|
| 1.
Be sure to adjust the camber before making toe adjustment.
|
| 2.
Adjust by turning the toe adjusting bolt (toe control arm mounting bolt which faces the
inside of the body).
Left wheel: Turning clockwise (-) toe-in
Right wheel: Turning clockwise (+) toe-in
|
)
)
)