REMOVAL AND INSTALLATION

M13702000057ENG0000010000

Pre-removal and Post-installation Operation

Power Steering Fluid Draining and Refilling (Refer to .) and Bleeding (Refer to .)

		Removal steps
	1.	Oil reservoir bracket
	2.	Oil reservoir
>>C<<	3.	Suction hose
	4.	Eye bolt
	5.	Gasket
	6.	Pressure hose bracket assembly
>>A<<	7.	Pressure hose assembly
	8.	O-ring
>>B<<	9.	Return hose
>>A<<	10.	Return tube assembly
>>A<<	11.	Return hose
	12.	Cooler tube assembly
>>A<<	13.	Return hose
>>A<<	14.	Return tube assembly
	15.	Return hose
>>A<<	16.	Return tube assembly
	17.	O-ring

		Removal steps
	1.	Oil reservoir bracket
	2.	Oil reservoir
>>C<<	3.	Suction hose
	4.	Eye bolt
	5.	Gasket
	6.	Pressure hose bracket assembly
>>A<<	7.	Pressure hose assembly
	8.	O-ring
>>B<<	9.	Return hose
>>A<<	10.	Return tube assembly
>>A<<	11.	Return hose
	12.	Cooler tube assembly
>>A<<	13.	Return hose
>>A<<	14.	Return tube assembly
	15.	Return hose
>>A<<	16.	Return tube assembly
	17.	O-ring

INSTALLATION SERVICE POINTS

>>A<< RETURN TUBE ASSEMBLY/ RETURN HOSE/ PRESSURE HOSE ASSEMBLY INSTALLATION

1. Align the mating marks on the gear box, return tube assembly and pressure tube assembly when installing.
2. Install so that the mating marks and upward.

3. Install so that the markings are faced upward.

>>B<< RETURN HOSE INSTALLATION

Install the return hose so that the markings and lines are faced rearward.

>>C<< SUCTION HOSE INSTALLATION

1. Install the suction hose so that the marking is positioned upward.