REMOVAL AND INSTALLATION


warning
  • Never attempt to disassemble or repair the passenger’s air bag cut off switch. If faulty, replace it.

  • Do not drop or subject the passenger’s air bag cut off switch to impact or vibration. Replace the passenger’s air bag cut off switch, if a dent, cracking, deformation, or rust is present.
Pre-removal Operation
  • Turn the ignition key to the "LOCK" (OFF) position.




Removal steps


·
 Disconnect the negative battery terminal.


·
 Glove box assembly (Refer to GROUP 52A, Instrument panel assembly ).


1.
 Passenger’s air bag cut off switch



Installation steps


·
 Connect the negative battery terminal.

>>A<<
 ·
 Pre-installation inspection


·
 Disconnect the negative battery terminal.

>>B<<
 1.
 Passenger’s air bag cut off switch


·
 Glove box assembly (Refer to GROUP 52A, Instrument panel assembly ).


·
 Connect the negative battery terminal.

>>C<<
 ·
 Post-installation inspection

INSTALLATION SERVICE POINTS

>>A<< PRE-INSTALLATION INSPECTION
Check the passenger’s air bag cut off switch for dents, breakage and bending and measure the resistance between the terminals, even when installing a new passenger’s air bag cut off switch.

>>B<< PASSENGER’S AIR BAG CUT OFF SWITCH INSTALLATION

warning If the passenger’s air bag cut off switch is not installed securely and correctly, the passenger’s (front) air bag may not operate normally.
Securely connect the connector.

>>C<< POST-INSTALLATION INSPECTION
1.Reconnect the negative battery cable.
2.Turn the ignition switch to the "ON" position.

3.Does the SRS warning lamp illuminate for about 7 seconds, and go out?
4.If no, refer to troubleshooting (Refer to).

5.Does the passenger’s air bag off indicator lamp illuminate for about 7 seconds, and go out?
6.If no, refer to troubleshooting (Refer to).