REMOVAL AND INSTALLATION <4M4>


Pre-removal Operation
  • Engine Coolant Draining (Refer to ).
  • A/C Compressor Drive Belt Removal (Refer to GROUP 11E - Crankshaft pulley ) <4M40>.
  • A/C Compressor Drive Belt Removal (Refer to GROUP 11G - Crankshaft pulley ) <4M41>.
  • Cooling Fan and Cooling Fan Clutch Assembly Removal <4M4> (Refer to ).

 Post-installation Operation
  • Cooling Fan and Cooling Fan Clutch Assembly Installation <4M4> (Refer to ).
  • A/C Compressor Drive Belt Installation (Refer to GROUP 11E - Crankshaft pulley ) <4M40>.
  • A/C Compressor Drive Belt Installation (Refer to GROUP 11G - Crankshaft pulley ) <4M41>.
  • Engine Coolant Refilling (Refer to ).
  • Alternator Drive Belt Tension Check and Adjustment (Refer to GROUP 11E - On-Vehicle Service, Drive Belt Tension Check and Adjustment ) <4M40>.
  • A/C Compressor Drive Belt Tension Check and Adjustment (Refer to GROUP 11E - On-Vehicle Service, A/C Compressor Drive Belt Tension Check and Adjustment ) <4M40>.
  • Alternator and A/C Compressor Drive Belt Tension Check and Adjustment (Refer to GROUP 11G - On-Vehicle Service, Drive Belt Tension Check and Adjustment ) <4M41>.




Removal steps
<<A>>
1.
 Alternator drive belts


2.
 Coupling plate


3.
 Cooling fan pulley


4.
 Water pump

>>A<<
 5.
 O-ring

REMOVAL SERVICE POINT

<<A>> ALTERNATOR DRIVE BELT REMOVAL

1.Loosen the locking nut of the tension pulley.
2.
caution To reuse the drive belt, draw an arrow indicating the rotating direction (clockwise) on the back of the belt using chalk, etc.
Rotate the adjusting bolt to the anti-clockwise direction (to the left), and remove the drive belt.

INSTALLATION SERVICE POINT

>>A<< O-RING INSTALLATION
caution Be careful not to contaminate the O-ring with engine oil or grease.
Apply water around the O-ring before installing it.