)
4.
| caution | Be careful not let the inhibitor switch slip out of place. |
Tightening torque: 5.4 ± 1.5 N·m
| 1.Move the selector lever to the N position. |
| 2.Loosen the T/M control cable adjusting nut, and the inhibitor switch adjusting bolt. |
|
3.Turn the inhibitor switch to adjust so that the "A" shown in the figure and the scribe line of inhibitor switch match. 4.
Tightening torque: 5.4 ± 1.5 N·m |
) |
5.Gently push the transmission control cable in the direction as shown in the illustration, and tighten the adjusting nut the specified torque. Tightening torque: 24 ± 3 N·m 6.Check that the selector lever is at the N position. 7.Check that the transmission shifts to the correct range corresponding to the position of the selector lever, and that it functions correctly in that range. |