|
|
If the dust cover is damaged accidentally during service work, replace the dust cover as follows:
|
|
2.Apply multipurpose grease to the inside of the dust cover as shown.
Specified grease
Multipurpose grease SAE J310, NLGI No.2 or equivalent
Usage: 10.0 ± 1.0 g
3.Apply multipurpose grease to the shown parts inside the dust cover and the ball joint stud.
Specified grease
Multipurpose grease SAE J310, NLGI No.2 or equivalent
Usage: As required
4.Wrap plastic tape around the lower arm ball joint stud, and then install the dust cover to the lower arm ball joint.
|
|
5.
| caution |
Do not apply grease to the place (tapered section) where the threaded section of the ball joint connects with the knuckle. Wipe the grease off if it is applied in this area.
|
Use special tool ball joint remover and installer (MB990800) to drive the dust cover into the position shown in the illustration.
6.
| caution |
To prevent the grease from being applied to the ball joint connection (taper) with the knuckle, do not compress the dust cover before installation.
|
Press the dust cover with your finger to check that there are no cracks or damage in the dust cover.
|
)
)