HEADLAMP REMOVAL AND INSTALLATION


Post-installation operationCheck the beam direction of the headlamp (Refer to Headlamp Aiming ).




Removal Steps


·
 Front bumper assembly (Refer to GROUP 51 - Front Bumper Assembly .)


1.
 Headlamp assembly


2.
 Headlamp bulb socket cover <Vehicles with discharge headlamp>
<<A>>
3.
 Headlamp bulb (Low-beam) <Vehicles with discharge headlamp>


4.
 Headlamp bulb (Low-beam) <Vehicles without discharge headlamp>


5.
 Headlamp bulb (High-beam)


6.
 Bulb socket


7.
 Front turn-signal lamp bulb


8.
 Bulb socket


9.
 Position lamp bulb


10.
 Headlamp control unit <Vehicles with discharge headlamp>


11.
 Headlamp bracket

REMOVAL SERVICE POINT

<<A>> HEADLAMP BULB REMOVAL <VEHICLES WITH DISCHARGE HEADLAMP>
caution Do not touch the bulb surface with bare hands or dirty gloves. If the bulb surface (glass part) gets dirty, immediately clean it with alcohol or thinner. After drying completely, install the bulb.

1.Twist the headlamp bulb socket cover to remove.

2.Disconnect the connector.
3.Turn the igniter to remove.
4.Release the bulb securing spring, and remove the bulb.