![](../../../img/21/AK600943AC00ENG.png)
|
Apply the specified grease to the clutch release bearing inside, and fill grease in the
groove. Specified lubricants: Mitsubishi Part No. 0101011 or equivalent
|
![](../../../img/21/AK600944AC00ENG.png)
|
Apply the specified grease to contact surface of release fork and release fork shaft. Specified lubricants: Mitsubishi Part No. 0101011 or equivalent
|
![](../../../img/21/AK600945AC00ENG.png)
|
Press fit the sealing cap into the transmission as shown. It must be 2 mm below the housing
surface.
|
![](../../../img/21/AK600946AC00ENG.png)
|
Apply the specified grease to contact surface of clutch release cylinder and push rod. Specified lubricants: Mitsubishi Part No. 0101011 or equivalent
|
![](../../../img/21/AK702166AB00ENG.png)
|
Apply the specified grease to the clutch disc splines and rub it in splines with a brush. Specified lubricants: Mitsubishi Part No. 0101011 or equivalent
|
![](../../../img/21/AK500600AO00ENG.png)
![](../../../img/21/AK603295AF00ENG.png)
|
Install the clutch cover, aligning its installation position with the dowel pins, and
then tighten the bolts to the specified torque of 19 ± 3 N·m in the order
shown in the illustration.
|