|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80°C to 90°C.
|
|
2.
warning |
Use care as oil could be hot.
|
Remove the engine oil filler cap.
|
|
3.Remove the drain plug to drain oil.
|
|
4.Install a new drain plug gasket so that it faces in the direction shown in the illustration,
and then tighten the drain plug to the specified torque. Tightening torque: 39 ± 5 N·m
|
|
5.Refill with specified quantity of oil. Specified Engine Oil
- ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5
- ILSAC classification: ILSAC certificated oil
- API classification: SM or higher
Total quantity (Includes volume inside oil filter and oil cooler): 4.9 L
note |
SAE 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet ACEA A3/B3, A3/B4
or A5/B5 and API SM or higher specification.
|
6.Install the engine oil filler cap. 7.Check oil level.
|