|
1.Bend the outside periphery of dust cover inward with a wooden hammer.
|
|
2.After special tool bearing remover (MB990560) has been installed as shown, tighten the nut of the special tool until the portion of the special tool touches the bearing outer race.
|
|
3.Press out the inner shaft from the bearing.
|
|
Press-fit the new dust seal into the housing tube by using the following special tools, until it is flush with the housing tube end face.
- Installer bar (MB990938)
- Oil seal installer (MB990955)
|
|
Using a steel pipe, install a new dust cover onto the inner shaft.
Steel pipe
|
mm
|
Overall length
|
50
|
Outside diameter
|
70
|
Wall thickness
|
4
|
|
|
Use special tool bearing remover (MB990560) to press-fit the bearing onto the inner shaft.
|
)
)
)
)
)
)
)